Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
If my crank pulley starts to wobble, because it appears to be. Even the belts are screeching a bit. Would one of the crank wobble savers ( with the longer...
-
Yes, there's a sensor by the crank shaft
I will confirm the TDC and the mark next chance I get....
Leave a comment:
-
-
Moved the timing to this and AFR at idle without any of the SC is at 14.8-15.1...
Leave a comment:
-
Is the only means of adjusting idle rpm the stop screw in the side of the throttle body? What size is the Allen key? Can't seem to fit any because of...
Leave a comment:
-
Without the diagnosis wire connected it reads this rpm at idle...
Leave a comment:
-
Was going to adjust the timing but then noticed the manual says that under the diagnosis mode, it would be idling at 850 but it isn't ...
Leave a comment:
-
About how much vacuum should the line that goes to the cards be reading at idle? I see -17.5in/Hg and removing the fuel pressure vacuum line gets the...
Leave a comment:
-
Removed everything and as the car has warmed up AFR has been consistent at about 17 AFR
Leave a comment:
-
Will do.
I started thinking about the fuel system and I might do further testing on it. Any chance the changes I made to the fuel pressure regulator's...
Leave a comment:
-
I was curious about the timing and ran the light on it again. Looks to be running around 5 BTDC. Might need a minor adjustment, could it be the problem?...
Leave a comment:
-
After further inspection, once the car goes into closed loop, after warming up, idle is very lean and the car appears to idle roughly.
Would...
Leave a comment:
-
Yes, the numbers I listed was with everything back together, and the CEL was on.
Funny note, the CEL did not come on when I tested without belt...
Leave a comment:
-
-
Did some further testing with the SC belt and with and without the first Oxygen sensor
without the sensor, AFR was consistently around 16.6-17...
Leave a comment:
-
Ok, I did some testing, but I should add a note about another variable that may play into it.
To combat the lean ness, i was suggested to add some...
Leave a comment:
-
One question, is the MAF used for the kit different from the stock one? Id like to bench test it. Do you have specs?
Leave a comment:
-
-
Thanks, hopefully that fixes something but given that prior to that leak the wideband has never at the proper AFR, what other things should I be testing...
Leave a comment:
-
Outbox is clear, all emails appear in the sent folder.
I just replied to two different old email threads and also sent an email from a different...
Leave a comment:
No activity results to display
Show More
Leave a comment: